6v6s for lite IIb or superlite pcb
Moderators: zaphod_phil, CurtissRobin, colossal
-
- Occasional poster
- Posts: 182
- Joined: Thu 08/07/08 2:00 am
- Location: sofla
6v6s for lite IIb or superlite pcb
from the offerings of NEW 6v6 tubes--JJ, EH, Tung Sol RI, etc, what are opinions from members. i have a set of EH my amp now (amp was discussed at length in another thread) and they are pretty good. the amp has Sovtek 12ax7wa's and a Sovtek 5ar4 (right now i was trying a Sylvania NOS 5y3--sounds better to me). switching preamp tubes around with different ones would make the most difference. i'm going to hit ebay and start looking for some decent, affordableNOS. i seem to like Sylvania overall.
how much difference would a decent NOS 5ar4 rectifier tube make over the Sovtek?
thanks
my other reason for asking is that i am still interested in doing a superlite pcb, but will do it with 6v6s if i do. i just like 6v6s bettter than el84s
how much difference would a decent NOS 5ar4 rectifier tube make over the Sovtek?
thanks
my other reason for asking is that i am still interested in doing a superlite pcb, but will do it with 6v6s if i do. i just like 6v6s bettter than el84s
0 x
-
- Verbose poster
- Posts: 1328
- Joined: Tue 08/03/04 2:00 am
- Location: Texas
The 5AR4 is basically the same tube as a GZ34 so it will drive your voltage up quite bit.
The JJ 6V6's are good tubes that sound good. They can take voltage and are tough.
I haven't tried the Tung-Sol 6V6's yet but folks seems to like them. From what I've read they have a smooth, bluesy break up and are more quiet volume wise than the JJ's.
Ken
The JJ 6V6's are good tubes that sound good. They can take voltage and are tough.
I haven't tried the Tung-Sol 6V6's yet but folks seems to like them. From what I've read they have a smooth, bluesy break up and are more quiet volume wise than the JJ's.
Ken
0 x
- zaphod_phil
- Builder, Admin
- Posts: 15208
- Joined: Wed 03/19/03 2:00 am
- Location: YYZ
-
- Occasional poster
- Posts: 182
- Joined: Thu 08/07/08 2:00 am
- Location: sofla
but is a Sovtek 5AR4 a true 5AR4? i know that the Sovtek 5Y3 jacks up the voltage. the amp calls for a 5AR4, but just for the time being i have an NOS Sylvania 5Y3 in it.
i get the feeling that as for 6V6s, short of buying some RCA blackplates, the consensus is to buy decent tubes and spend my money on preamp tubes and later on a speaker. close???
i get the feeling that as for 6V6s, short of buying some RCA blackplates, the consensus is to buy decent tubes and spend my money on preamp tubes and later on a speaker. close???
0 x